Operation Manual

6
A31008-N2511-F101-1-2X43 SECURITY LEAFLET SENSOR CH en 28.01.2014
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or
microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances
can cause
changes to the device’s
exterior. Due to the wide variety of chemical products available on the market, it
was not possible to test all substances.
Impairments in high-gloss finishes can be ca
r
efully removed using display polishes
for mobile phones.
Contact with liquid
If one of the components comes into contact with liquid:
1 Disconnect the device from the power supply or remove the batteries.
2 Allow the liquid to drain from the device.
3 Pat all parts dry.
4 Place the device in a dry, warm place for at least 72 hours 
(not in a microwave, oven etc.).
5 Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
!