Operation Manual

4
A31008-N2511-F101-1-2X43 SECURITY LEAFLET SENSOR CH en 28.01.2014
Important notes on installation and use
Use
Gigaset elements sensors and actuators are an extension of the Gigaset elements
starter kit.
Requirements
To use the Gigaset elements sensors and actuators efficiently, the installed and
fully functional Gigaset elements starter kit is required.
Installation
Gigaset elements sensors and actuators are designed for use in dry rooms in a
temperature range of +5 °C to +45 °C.
The range is up to 300m in unobstructed outdoor areas und up to 50 m inside
bui
l
dings.
Gigaset elements door and window have to be glued with the sticky tapes pro-
vided.
Set up Gigaset elements motion either wit
h
the mounted pedestal or with the
enclosed sticky tapes or install it on the wall with the enclosed screws and dowels.
A description of where to ideally install the sensors and actuators can be found in
the
en
closed leaflet “First Steps“.
Please contact the Gigaset elements customer service if you have any questions.
Notes on the sticky tapes
u Glue the sensors to clean, dry surfaces only which are also free of grease and
if possible smooth and stable.
u Optimal bonding is achieved after approx. 48 hours.
u The sticky tapes are designed for use once only.
u Only use the sticky tapes provided.
Gigaset elements GmbH is not liable for potential damage to surfaces which may
oc
cu
r through glueing, mounting, assembling or removal of the Gigaset elements
sensors and actuators.
Warning
Never expose the Gigaset sensors and actuators to the influence of heat
sources, direct sunlight or other electrical devices and protect it from moisture,
dust, corrosive ligquids and fumes.