User's Manual

50
Using a handset as a room monitor
Gigaset S790/S795 / USA-CAN EN / A31008-M2121-R301-1-3S19 / registr_sett.fm / 28.07.2009
Version 4, 16.09.2005
Activating the room monitor and
entering the destination number
v
¢ É ¢ Room Monitor
¤ You can enter data in the following
fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
ö) or enter it manually.
Internal number: Select display key
§Change§ ¢ . Select handset or Call All to
call all registered handsets ¢
§OK§.
In idle status, the destination number
or the internal destination number
dis-
plays
.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤ Press §Save§ to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination number
v ¢ É ¢
Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and
entering the destination number"
(
¢ page 50).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
§Off§ to
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support
tone
dialing and the room monitor should
be set for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further
room monitor calls. The other room moni-
tor settings on the handset (e.g., no ring-
tone) will remain activated until you press
the display key
§Off§ on the handset.
To reactivate the room function with the
same phone number:
¤ Turn on the activation again and save
with §Save§ (¢ page 50).
Warning!
u Always check the operation of the
room monitor before use. For
example, test its sensitivity.
Check the connection if you are
diverting the room monitor to an
external number.
u When the function is switched on,
the handset's operating time is con-
siderably reduced. If necessary,
place the handset in the base/
charger. This ensures that the bat-
tery does not run down.
u Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u The connection to which the room
monitor is diverted must not be
blocked by an activated
answering
machine.
i à V
07:15 am
INT 1 Oct 22
Á
Room Monitor
9725551234
Off Options