User's Manual

49
Using a handset as a room monitor
Gigaset S790/S795 / USA-CAN EN / A31008-M2121-R301-1-3S19 / registr_sett.fm / 28.07.2009
Version 4, 16.09.2005
Changing the name of a handset
The names "INT 1", "INT 2" etc. are
assigned automatically on registration.
You can change these names. The name
must be no more than 10 characters. The
changed name
displays in every handset's
list.
u Open the list of handsets. Your
own handset is indicated by
f
.
s Select handset.
§Options§ Open menu.
Rename
~ Enter name.
§Save§ Press the display key.
Changing a handset's internal
number
A handset is automatically assigned the
lowest free number when it is registered.
If all slots are occupied, number 6 is over-
written if this handset is in idle status. You
can change the internal number of all reg-
istered handsets (1–6).
u Open the list of handsets. Your
own handset is indicated by
f
.
§Options§ Open menu.
Assign Handset No.
Select and press §OK§.
r Select number. Only numbers
that have not been assigned
are displayed.
§Save§ Press the display key to save
the input.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
All of the handset keys are deactivated,
with the exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) is terminated
after approximately 3 minutes (depending
on the base). When the room monitor is
activated, all keys are locked except the
end call key. The handset's speaker is
muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringtone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.