User's Manual
Table Of Contents
- Safety precautions
- Package contents
- Connection overview
- Preparing the handset
- Inserting the supplied batteries and closing the battery cover
- Connecting the charger and charging the batteries
- Connecting the phone cord and power lead to the base
- Connecting the base to the fixed line network and mains power supply
- Connecting the base to the router (Internet)
- Connecting the PC to the router (optional)
- Connecting the base
- Connecting the base
- Configuring the VoIP connection
- Prerequisite for the following steps:
- You will need:
- Starting the configuration process
- Starting the VoIP wizard
- Entering an auto-configuration code
- Selecting a provider and loading provider data to the base
- Entering personal VoIP account data
- Starting the connection wizard
- Completing the installation
- Entering your name in the Gigaset.net directory
- Configuring the VoIP connection
- Configuring the VoIP connection
- Configuring the VoIP connection
- Configuring the VoIP connection
- Assigning the send/receive connection
- Assigning the send/receive connection
- Assigning the send/receive connection
- Assigning the send/receive connection
- Gigaset.net directory entry
- Making calls / operating the answering machine
- FCC / ACTA Information
- Safety precautions
- Service (Customer Care)
- Service (Customer Care)
- Service (Customer Care)
- Service (Customer Care)
- FCC / ACTA Information
Gigaset C590/595 IP / USA EN / A31008-M2215-R301-1-6043 / configuration_10pg.fm / 11/10/10
Version 5, 23.09.2008
10
Configuring the VoIP connection
Starting the configuration process
When your handset is sufficiently charged (approx. 20 minutes after you have placed it in the
charger), the message key f on the handset flashes.
Starting the VoIP wizard
> Press the message key f on the handset.
If "New firmware available" is shown in the display, updated firmware is already available for
your phone. Press the right-hand display key §Yes§. The new firmware is loaded. This takes approx.
6 minutes. The message key fwill now flash again.
> Press the message key f to start configuration.
> Press the key below
§Yes§ on the display
(= right display key).
> Press the bottom of the control key s
to scroll down.
> Press the §OK§ display key to continue.
If the connection wizard does not start correctly, or if you cancel the connection wizard, you can
start it via the following menu on the handset:
p (press right) ¢ Ï ¢ Telep hony ¢ VoIP Wizard
7
8
IP Wizard
?
Start IP
installation wizard?
No Yes
IP Wizard
Ð
This wizard helps
you to configure an
IP account and
register it with your
provider so you can -
V
OK