User's Manual

42
Using multiple handsets
Gigaset A510-A510A / USA en / A31008-M2202-R301-1-3S19 / registr_sett.fm / 25.08.2011
Version 4, 16.09.2005
Using multiple handsets
Registering handsets
You can register up to four handsets on your
base. Each additional handset must be regis-
tered with the base in order for it to work
properly!
Registering a Gigaset handset to a
Gigaset A510/A510A
You must manually register the handset on
both the handset (1) and the base (2).
Once registration is complete, the handset
returns to idle status. The handset's internal
number is shown on the display, e.g., INT 1.
If not, repeat the procedure.
Registering other handsets
You can manually register other Gigaset
handsets and handsets for other devices
with GAP functionality as follows.
De-registering handsets
You can de-register all other registered
handsets from each of the registered
Gigaset handsets.
§Menu§ ¤ Settings ¤ Registration
¤ De-register Handset
s Select the internal number
you wish to de-register and
press
§OK§.
(The handset you are currently
using is highlighted with <).
~ Enter the current system PIN
and press
§OK§.
§OK§ Press the display key.
Locating a handset (paging)
You can locate your handset using the base.
¤ Briefly press the register/paging key on
the base (¢ page 5).
¤ All handsets will ring at the same time
("paging"), even if the ringtones are
switched off.
Ending paging
¤ Briefly press the registration/paging key
on the base or press the talk key c or
end call key a on the handset.
Making internal calls
Internal calls are free calls between handsets
that are registered with the same base.
Calling a specific handset
u Initiate internal call.
~ Enter the number of the hand-
set.
Or:
u Initiate internal call.
s Select handset.
c Press the talk key.
1) On the handset
§Menu§ ¤ Settings ¤ Registration
¤ Register Handset
~ If required, enter the system
PIN for the base (the default is
0000) and press
§OK§.
The display shows Handset is registering.
2) On the base
¤ Within 60 seconds, press and hold the
register/paging key on the base
(¢ page 5) (for approx. 3 seconds).
1) On the handset
¤ Start to register the handset as
described in its user guide.
2) On the base
¤ Press and hold the register/paging key
on the base (¢ page 5) (approx. 3 sec.).