User's Manual

Table Of Contents
14
First steps
Gigaset A510-A510A / USA en / A31008-M2202-R301-1-3S19 / starting.fm / 25.08.2011
Version 4, 16.09.2005
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully
charged and discharged.
¤ Charge the handset in the base for 6 hours.
¤ After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
If you have any questions about using your phone, please read the tips
on troubleshooting (¢ page 55) or contact our Customer Care team
(¢ page 52).
Please note
The handset must only be placed in the designated Gigaset A510/A510A base
or charger.
6h
Please note
u The handset is pre-registered with the base. If you have purchased a model
with multiple handsets, all handsets will already be registered with the
base. You do not need to register the handset again.
However, if a handset is not registered with the base (Register handset or
Place handset in base flashes on the display), please register the handset
manually ¢ page 42.
u After the first battery charge and discharge, you may place your handset in
the charger after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.