User Manual

- 70 -
Conguring a RAID Set
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B.ConguringSATAcontrollermodeinBIOSSetup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go to
Peripherals\SATAAndRSTConguration, make sure SATA Controller(s) is enabled. To create RAID, set
SATA Mode Selection to Intel RST Premium With Intel Optane System Acceleration (Figure 1). Note: When
using a PCIe SSD, make sure to set the Use RST Legacy OROM item under Peripherals\SATA And RST
Conguration to Disabled. Then depending the M.2 connector you use, set the corresponding PCIe Storage
DevonPortXX item to RST Controlled. Finally, save the settings and exit BIOS Setup.
Step 2:
To use the EZ RAID feature, follow the steps in "C-1." To congure UEFI RAID, follow the steps in "C-2." To
enter the legacy RAID ROM, refer to "C-3" for more information. Finally, save the settings and exit BIOS Setup.
Figure 1