User Manual

USB  Chipset:
- 2 x USB 3.1 Gen 2 Type-A ports (red) on the back panel
- 1 x USB Type-C
™
port with USB 3.1 Gen 1 support, available through the
internal USB header
- 6 x USB 3.1 Gen 1 ports (4 ports on the back panel, 2 ports available through
the internal USB header)
 Chipset+2 USB 2.0 Hubs:
- 8 x USB 2.0/1.1 ports (4 ports on the back panel, 4 ports available through
the internal USB headers)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x 4-pin ATX 12V power connector
 2 x M.2 Socket 3 connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 1 x water cooling CPU fan header
 3 x system fan/water cooling pump headers
 2xdigitalLEDstripheaders
 2xdigitalLEDstrippowerselectjumpers
 2xRGBLEDstripheaders
 1 x front panel header
 1 x front panel audio header
 1 x USB Type-C
™
port, with USB 3.1 Gen 1 support
 1 x USB 3.1 Gen 1 header
 2 x USB 2.0/1.1 headers
 1xS/PDIFOutheader
 1 x Trusted Platform Module (TPM) header (2x6 pin, for the GC-TPM2.0_S
module only)
 1 x Thunderbolt
™
add-in card connector
 1 x Clear CMOS jumper
Back Panel
Connectors
 4 x USB 2.0/1.1 ports
 1xHDMIport
 4 x USB 3.1 Gen 1 ports
 2 x USB 3.1 Gen 2 Type-A ports (red)
 1 x RJ-45 port
 1xopticalS/PDIFOutconnector
 5 x audio jacks
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Watercoolingowratedetection
 Overheating warning
 Fan fail warning
 Fan speed control
 * Whetherthefan(pump)speedcontrolfunctionissupportedwilldependonthefan
(pump) you install.
- 7 -