User's Manual

- 12 -
Hardware Installation
Internal
Connectors
 1 x front panel header
 1 x front panel audio header
 1 x USB Type-C
™
port, with USB 3.2 Gen 2 support
 2 x USB 3.2 Gen 1 headers
 3 x USB 2.0/1.1 headers
 1 x noise detection header
 1 x Thunderbolt
™
add-in card connector
 1 x Trusted Platform Module (TPM) header (2x6 pin, for the GC-TPM2.0_S
module only)
 1 x power button
 1 x reset button
 2 x temperature sensor headers
 1 x Clear CMOS jumper
 2 x BIOS switches
Back Panel
Connectors
 1 x Q-Flash Plus button
 1 x Clear CMOS button
 1 x USB Type-C
™
port, with USB 3.2 Gen 2 support
 1 x USB 3.2 Gen 2 Type-A port (red)
 6 x USB 3.2 Gen 1 ports
 2 x USB 2.0/1.1 ports
 2 x RJ-45 ports
 2 x SMA antenna connectors (2T2R)
 1 x optical S/PDIF Out connector
 5 x audio jacks
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Watercoolingowratedetection
 Overheating warning
 Fan fail warning
 Fan speed control
* Whether the fan (pump) speed control function is supported will depend on the fan
(pump) you install.
 Noise Detection
BIOS  2x128Mbitash
 Use of licensed AMI UEFI BIOS
 Support for DualBIOS
™
 PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0