Operation Manual

ManualsBrandsGigabyte ManualsAudiogn bt01h

English

Volume Up

Preparing The Headset

GN-BT01H Bluetooth headset can be connected to any device with

Bluetooth wireless technology that supports handsfree profile.

Microphone

Volume Down

Call Handlin

Button

Mode Button

Indicator Li

Speaker

Front

Back

Summary of content (4 pages)

PAGE 1
GN-BT01H Bluetooth headset can be connected to any device with Bluetooth wireless technology that supports handsfree profile.
PAGE 2
English Top USB Connector Dongle Mode Indicator Getting Started Before you start to use this headset you should ♦ Charge the headset. ♦ Pair the headset with a device. Charging First Time Charging : GN-BT01H must be charged fully before you use headset for the first time. During Charging : Indicator light shows steady RED light. Fully Charged : Indicator light goes off. The headset can be charged either using a power adapter or a USB cable charging from PC.
PAGE 3
Pairing the Headset Before you use the headset, you must pair the headset with a device. 1. Follow mobile phone user guide on “how to turn on Bluetooth and add a Bluetooth device” to mobile phone. 2. Set into paiting mode. Press “Volume Up” and “Call Handling Button” buttons together for 3 secods until the indicator light flash blue and green. The headset is now ready for pairing. 3. Continue follow the instruction of the mobile phone’s user manual to add the headset into list. 4.
PAGE 4
English Dongle Mode Setting The headset can be configured as a Bluetooth USB dongle. The USB dongle can be used to transfer data between mobile phone and PC. Set To Dongle Mode Press “Mode Button” and “Call Handling Button” together for 3 seconds. Dongle Mode indicator turns on as green. Set To Headset Mode Unplug USB Cable; the headset will automatically switch off. Headset goes to headset mode when you turn on headset.