User`s manual

BIOS Setup - 46 -

USB Controllers

Enables or disables the integrated USB controller. (Default: Enabled)

Disabled will turn off all of the USB functionalities below.

USB Legacy Function

Allows USB keyboard to be used in MS-DOS. (Default: Enabled)

USB Storage Function

 Determineswhether to detect USB storagedevices, including USB ash drivesandUSB hard drives

during the POST. (Default: Enabled)

Azalia Codec

Enables or disables the onboard audio function. (Default: Auto)

If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to

Disabled.

Onboard H/W LAN

Enables or disables the onboard LAN function. (Default: Enabled)

If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to

Disabled.

SMART LAN

Start detecting at Port.....

Part1-2 Status = Open / Length = 0m

Part3-6 Status = Open / Length = 0m

Part4-5 Status = Open / Length = 0m

Part7-8 Status = Open / Length = 0m

higf

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Item Help

Menu Level



SMART LAN (LAN Cable Diagnostic Function)

This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN

cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to

the following information for diagnosing your LAN cable:

When No LAN Cable Is Attached...

If no LAN cable is attached to the motherboard, the StatuseldsofallfourpairsofwireswillshowOpen

and the Lengtheldsshow0m,asshowninthegureabove.

When LAN Cable Is Functioning Normally...

If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub, the

following message will appear:

Start detecting at Port.....

Link Detected --> 100Mbps

Cable Length= 30m

Link Detected Displays transmission speed.

Cable Length Displays the approximate length of the attached LAN cable.

Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate at a

normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is activated.