User`s manual

- 45 - BIOS Setup
2-5 Advanced BIOS Features
Internal Graphics Mode
Allows you to determine whether to allocate the system memory for the onboard graphics controller.
UMA Allocates memory for the onboard graphics controller from the system
memory.
UMA+SidePort Allocates memory for the onboard graphics controller from the system
memory and SidePort memory. (Default)
Disabled Disables the onboard graphics controller.
UMA Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics
controller. MS-DOS, for example, will use only this memory for display. Options are: Auto (default),
128MB, 256MB, 512MB.
Surround View
This option is configurable only when Init Display First is set to PEG. Enables or disables the
Surround View function. This option is configurable only if an ATI graphics card is installed.
(Default: Disabled)
Onboard VGA output connect
Specifies the graphics display of the onboard VGA output from the D-SUB/DVI-D or D-SUB/HDMI.
D-SUB/DVI Sets the D-SUB/DVI-D as the graphics display. (Default)
D-SUB/HDMI Sets the D-SUB/HDMI as the graphics display.
AMD C1E Support
Enables or disables the C1E CPU power-saving function in system halt state. When set to
Software SMI, the CPU core frequency and voltage will be reduced during system halt state to
decrease power consumption. (Default: Software SMI)
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Advanced BIOS Features
Internal Graphics Mode [UMA+SidePort]
UMA Frame Buffer Size [Auto]
x Surround View Disabled
Onboard VGA output connect [D-SUB/DVI]
AMD C1E Support [Software SMI]
Virtualization [Disabled]
Patch AMD TLB Erratum
(Note)
[Enabled]
AMD K8 Cool&Quiet control [Auto]
 Hard Disk Boot Priority [Press Enter]
First Boot Device [Floppy]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Password Check [Setup]
HDD S.M.A.R.T. Capability [Disabled]
Away Mode [Disabled]
Init Display First [PCI Slot]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
(Note) This item is present only if you install a CPU that supports this feature.