User`s manual

GA-M52L-S3P Motherboard - 68 -

Serial-ATA RAID Config

Item Help

Menu Level

NV SATA RAID function [Enabled]

NV SATA 1 Primary RAID [Enabled]

NV SATA 1 Secondary RAID [Enabled]

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

B. Configuring SATA controller mode in BIOS Setup

Make sure to configure the SATA controller mode correctly in system BIOS Setup.

Step 1:

Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).

Under Integrated Peripherals, ensure NV SATA Controller is enabled. To configure a RAID array,

go to the Serial-ATA RAID Config submenu.

Figure 1

The BIOS Setup menus described in this section may differ from the exact settings for your

motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard

you have and the BIOS version.

Step 2:

Save changes and exit BIOS Setup.

Set NV SATA RAID function to Enabled to enable RAID control for the SATA connectors. Make sure

NV SATA 1 Primary RAID and NV SATA 1 Secondary RAID are enabled. (Figure 2)

Figure 2

Integrated Peripherals

On-Chip IDE Channel [Enabled]

NV SATA Controller [Enabled]

IDE Prefetch Mode [Enabled]

USB Memory Type [SHADOW]

 Serial-ATA RAID Config [Press Enter]

Onboard Audio Function [Auto]

On-Chip MAC Lan [Auto]

Onboard LAN Boot ROM [Disabled]

Onboard Serial Port 1 [3F8/IRQ4]

Onboard Parallel Port [378/IRQ7]

Parallel Port Mode [SPP]

x ECP Mode Use DMA 3

On-Chip USB [V1.1+V2.0]

USB Keyboard Support [Disabled]

USB Mouse Support [Disabled]

Legacy USB storage detect [Enabled]

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Item Help

Menu Level