User`s manual

- 23 -
2-3 MBIntelligentTweaker(M.I.T.)
Whether the system will work stably with the overclock/overvoltage settings you made is dependent
on your overall system congurations. Incorrectly doing overclock/overvoltage may result in dam-
age to CPU, chipset, or memory and reduce the useful life of these components. This page is for
advanced users only and we recommend you not to alter the default settings to prevent system insta-
bility or other unexpected results. (Inadequately altering the settings may result in system's failure to
boot. If this occurs, clear the CMOS values and reset the board to default values.)
(Note) This item is present only when you install a CPU that supports this feature.
IGXConguration
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
MB Intelligent Tweaker(M.I.T.)

 IGXConguration   [PressEnter]
 CPUClockRatio   [Auto] 2400Mhz
 CPUNBClockDivisor  [Auto]  
Core Performance Boost
(Note)
  [Enabled]
CPB Ratio
(Note)
  [Auto] 2400Mhz
 CPUHostClockControl  [Auto]
x CPU Host Clock 100
DRAME.O.C.P    [Disabled]
 SetMemoryClock   [Auto]
x Memory Clock x6.66 1333Mhz

 DRAMConguration   [PressEnter]
********
System Voltage Optimized
********
 SystemVoltageControl  [Auto]
x DDR3 Voltage Auto
x CPU Voltage Control Auto
x CPU NB VID Control Auto
Normal CPU Vcore 1.3750V
Normal CPU Vcore NB 1.0500V

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
IGXConguration

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

 InternalGraphicsMode  [UMA]
 UMAFrameBufferSize  [Auto]
x SurroundView    [Disabled]
 VGACoreClockcontrol  [Auto]
x VGA Core Clock(MHz) 444
Internal Graphics Mode
Allows you to determine whether to allocate system memory for the onboard graphics controller.
Disabled Disables the onboard graphics controller.

UMA Allocates memory for the onboard graphics controller from the system memory.

(Default)
 UMAFrameBufferSize
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics con-
troller. MS-DOS, for example, will use only this memory for display. Options are: Auto (default), 256MB,
512MB, 1024MB.