User Guide

Hardware Installation - 10 -
1-2 ProductSpecications
CPU  Support for Intel
®
Atom
®
C2000 series processor
 L1/L2 cache varies with CPU
Memory  4 x 1.35V/1.5V DDR3 DIMM sockets supporting up to 32 GB of system memory
 Dual channel architecture
 Support for DDR3 1600 MHz memory modules
 Support for ECC/non-ECC, un-buffered memory modules
LAN  Marvell
®
88E1543 Quad PHY supports 10/100/1000 Mbps
Onboard
Graphics
 Build-In ASPEED
®
2400 chipset
Storage Interface  2 x SATA 6Gb/s connectors
 4 x SATA 3Gb/s connectors
USB  2 x USB 2.0 ports (On the back panel)
Expansion Slots  1 x PCIe x16 slot (Gen2 x8 bus)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 2 x SATA 6Gb/s connectors
 4 x SATA 3Gb/s connectors
 1 x CPU fan header
 1 x System fan header
 2 x Front panel header
 1 x PMBus header
 1 x Trusted Platform Module connector
 1 x HDD back plane board header
 1 x HDD LED/LAN port active/Case open intrusion combination header
Back Panel
Connectors
 2 x USB 2.0 ports
 5 x RJ-45 ports (1 x 10/100 dedicated management LAN port)
 1 x COM port
 1 x VGA port
 1 x ID Switch button
 1 x Power button
 1 x Status LED
I/O Controller  ASPEED
®
AST2400 BMC chip
Hardware
Monitor
 System voltage detection
 CPU/System temperature detection
 CPU/System fan speed detection
 CPU/System fan speed control
* Whether the CPU/system fan speed control function is supported will depend on
the CPU/system cooler you install.