User manual

- 38 -
Press <Enter> on this item and type the password with up to 8 characters and then press <Enter>. You will be
UHTXHVWHGWRFRQ¿UPWKHSDVVZRUG7\SHWKHSDVVZRUGDJDLQDQGSUHVV(QWHU!7KH%,266HWXSSURJUDP
allows you to specify two separate passwords:
& Supervisor Password
When a system password is set and the Password Check item in Advanced BIOS Features is set to
Setup, you must enter the supervisor password for entering BIOS Setup and making BIOS changes. When
the Password Check item is set to System, you must enter the supervisor password (or user password)
at system startup and when entering BIOS Setup.
& User Password
When the Password Check item is set to System, you must enter the supervisor password (or user
password) at system startup to continue system boot. In BIOS Setup, you must enter the supervisor
password if you wish to make changes to BIOS settings. The user password only allows you to view the
BIOS settings but not to make changes.
To clear the password, press <Enter> on the password item and when requested for the password, press
<Enter> again. The message "PASSWORD DISABLED" will appear, indicating the password has been
cancelled.
 127(%HIRUHVHWWLQJWKH8VHU3DVVZRUGEHVXUHWRVHWWKH$GPLQLVWUDWRU3DVVZRUG¿UVW
Press <Enter> on this item and then press the <Y> key to load the optimal BIOS default settings. The BIOS
defaults settings help the system to operate in optimum state. Always load the Optimized defaults after updating
the BIOS or after clearing the CMOS values.
2-11 Load Optimized Defaults
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Load Optimized Defaults
`
MB Intelligent Tweaker(M.I.T.)
`
Standard CMOS Features
`
Advanced BIOS Features
`
Integrated Peripherals
`
Power Management Setup
`
PnP/PCI Con¿gurations
`
PC Health Status
ESC: Quit
KLJI
: Select Item F11: Save CMOS to BIOS
F8: Q-Flash F10: Save & Exit Setup F12: Load CMOS from BIOS
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Load Optimized Defaults (Y/N)? N
2-12 Set Supervisor/User Password
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Change/Set/Disable Password
`
MB Intelligent Tweaker(M.I.T.)
`
Standard CMOS Features
`
Advanced BIOS Features
`
Integrated Peripherals
`
Power Management Setup
`
PnP/PCI Con¿gurations
`
PC Health Status
ESC: Quit
KLJI
: Select Item F11: Save CMOS to BIOS
F8: Q-Flash F10: Save & Exit Setup F12: Load CMOS from BIOS
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Enter Password: