User manual

- 37 -
2-10 Load Fail-Safe Defaults
Press <Enter> on this item and then press the <Y> key to load the safest BIOS default settings. In case system
instability occurs, you may try to load Fail-Safe defaults, which are the safest and most stable BIOS settings
for the motherboard.
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Load Fail-Safe Defaults
`
MB Intelligent Tweaker(M.I.T.)
`
Standard CMOS Features
`
Advanced BIOS Features
`
Integrated Peripherals
`
Power Management Setup
`
PnP/PCI Con¿gurations
`
PC Health Status
ESC: Quit
KLJI
: Select Item F11: Save CMOS to BIOS
F8: Q-Flash F10: Save & Exit Setup F12: Load CMOS from BIOS
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Load Fail-Safe Defaults (Y/N)? N
& Hardware Thermal Control
Enables or disables the CPU overheating protection function. When enabled, the CPU core voltage and
ratio will be reduced when the CPU is overheated. (Default: Enabled)
& Reset Case Open Status
Disabled Keeps or clears the record of previous chassis intrusion status. (Default)
Enabled Clears the record of previous chassis intrusion status and the Case Opened¿HOGZLOO
show "No" at next boot.
& Case Opened
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
KHDGHU,IWKHV\VWHPFKDVVLVFRYHULVUHPRYHGWKLV¿HOGZLOOVKRZ<HVRWKHUZLVHLWZLOOVKRZ1R7R
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& Current Voltage(V) Vcore/DDR3 1.5V/+12V/+3.3V
Displays the current system voltages.
& Current System/CPU Temperature
Displays current System/CPU temperature.
& Current CPU/SYSTEM FAN Speed (RPM)
Displays current CPU/system fan speed.
& CPU Warning Temperature
Sets the warning threshold for CPU temperature. When CPU temperature exceeds the threshold, BIOS
will emit warning sound. Options are: Disabled (default), 60
o
C/140
o
F, 70
o
C/158
o
F, 80
o
C/176
o
F, 90
o
C/194
o
F.
& CPU/SYSTEM FAN Fail Warning
Allows the system to emit warning sound if the CPU/system fan is not connected or fails. Check the fan
condition or fan connection when this occurs. (Default: Disabled)
& CPU Smart FAN Control
Enables or disables the CPU fan speed control function. Enabled allows the CPU fan to run at different
speed according to the CPU temperature. You can adjust the fan speed with EasyTune based on system
requirements. If disabled, CPU fan runs at full speed. (Default: Enabled)