User manual

- 27 -
& HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto BIOS will automatically adjust the HT Link Frequency. (Default)
x1~x10 Sets HT Link Frequency to x1~x10 (200 MHz~2.0 GHz).
& Set Memory Clock
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the memory clock
as required. ManualDOORZVWKHPHPRU\FORFNFRQWUROLWHPEHORZWREHFRQ¿JXUDEOH'HIDXOW
& Memory Clock
 7KLVRSWLRQLVFRQ¿JXUDEOHRQO\ZKHQSet Memory Clock is set to Manual. Options are: X4.00, X5.33,
X6.66, X8.00.
& '5$0&RQÀJXUDWLRQ
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
DRAM Con¿guration
DCTs Mode [Unganged]
DDR3 Timing Items [Auto] SPD Auto
x 1T/2T Command Timing Auto -- --
x CAS# latency Auto 9T 9T
x RAS to CAS R/W Delay Auto 9T 9T
x Row Precharge Time Auto 9T 9T
x Minimum RAS Active Time Auto 24T 24T
x TwTr Command Delay Auto 5T 5T
x Trfc0 for DIMM1, DIMM3 Auto 110ns 110ns
x Trfc1 for DIMM2, DIMM4 Auto -- --
x Write Recovery Time Auto 10T 10T
x Precharge Time Auto 5T 5T
x Row Cycle Time Auto 33T 33T
x RAS to RAS Delay Auto 4T 4T
Channel Interleaving [Enabled]
Bank Interleaving [Enabled]
DQS Training Control [Skip DQS]
Memclock tri-stating [Disabled]
KLJI
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
`
& DCTs Mode
Allows you to set memory control mode.
Ganged Sets memory control mode to single dual-channel.
Unganged Sets memory control mode to two single-channel. (Default)
& DDR3 Timing Items
ManualDOORZVDOO'5$0WLPLQJFRQWUROLWHPVEHORZWREHFRQ¿JXUDEOH
Options are: Auto (default), Manual.
& 1T/2T Command Timing
Options are: Auto (default), 1T, 2T.
& CAS# latency
Options are: Auto (default), 4T~12T.
& RAS to CAS R/W Delay
Options are: Auto (default), 5T~12T.
& Row Precharge Time
Options are: Auto (default), 5T~12T.
& Minimum RAS Active Time
Options are: Auto (default), 15T~30T.