User`s manual

- 25 - Hardware Installation

9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by AMD SB710 South Bridge)

The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.

Each SATA connector supports a single SATA device. The AMD SB710 controller supports RAID 0,

RAID 1, RAID 10 and JBOD. Refer to Chapter 5, "Conguring SATA Hard Drive(s)," for instructions on

conguring a RAID array.

Pin No. Denition

1 GND

2 TXP

3 TXN

4 GND

5 RXN

6 RXP

7 GND

• A RAID 0 or RAID 1 conguration requires at least two hard drives. If more than two hard

drives are to be used, the total number of hard drives must be an even number.

• A RAID 10 conguration requires at least four hard drives and the total number of hard drives

must be an even number.

10) GSATA3_6/7 (SATA 6Gb/s Connectors, Controlled by Marvell 9128)

The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA

1.5Gb/s standards. Each SATA connector supports a single SATA device.

The Marvell 9128 supports

RAID 0 and RAID 1. Refer to Chapter 5, "Conguring SATA Hard Drive(s)," for instructions on conguring a

RAID array.

Pin No. Denition

1 GND

2 TXP

3 TXN

4 GND

5 RXN

6 RXP

7 GND

Please connect the L-shaped end of

the SATA 3Gb/s cable to your SATA

hard drive.

SATA2_0

SATA2_1 SATA2_4

SATA2_3

SATA2_5

G.QBOFM

SATA2_2

G.QBOFM

7 1

G.QBOFM

GSATA3_6

GSATA3_7