Owner's Manual

- 7 -

GH-PDU22-SC

English

Installation Instructions for Intel

Pentium

4 mPGA478 Clips

Figure 2

Clip introduction--

Part A: Secured to the retention mechanism hook.

Part B: Tightly contact the cooler bracket.

Part C: Secured to the retention mechanism hook.

Figure 1-1

Figure 1-2

Figure 3-1

Figure 4

Figure 3-2

Figure 4

Connect the 3-pin connector to the CPU fan connector on the

motherboard. Clips Installation is now complete.

If fan speed control is required, please refer to "Installation of

the Fan Speed Control Cable".

Figure 2

Figure 1

Please add an adequate layer of heat sink paste on the surface

of the CPU(Figure1-1). Figure 1-2 showing the correct

installation of the cooler atop the CPU.

Figure 3

Secure Parts A, B, and then C of the clip to the retention

mechanism. Assure that Part C is secured to the retention

mechanism hook on the same side as the heat pipes.