User`s manual

6-1-4 Cut and remove the nylon tie
which is used to fasten 4-way
splitter valve.
6-1-7 Remove the tube; let the water
from waterblock and the tube drift
into the pail.
6-1-3 Release the clip of waterblock
from CPU.
(Caution: Do not remove the tube
at this point)
6-1-6 Release the tube clip on the inlet
of the waterblock; and place the
waterblock on the top of the pail.
6-1-8 Release the tube clip on the inlet
of the tank and make sure if all the
coolant drifts out from the tube.
Remove the tube, tube clip and
spring.
6-1-5 Remove pump + tank and 4-way
splitter valve from the chassis;
and set a pail on a lower position
to fill the coming out coolant.
21
English