User Manual

Set Supervisor Password
A supervisor password must be set before a lower-level user password can be set. After
selecting Change Supervisor Password, press Enter. You will be prompted for the new
password, and then again to verify it. Type in 6 or fewer keystrokes. If you make an error, press
Esc to start over.
Set User Password
With a User password, you can enter the Setup Utility and change or remove the User
password, but you cannot enter the Setup Utility and change or remove the Supervisor
password, nor enable diskette access if it has been disabled.
4.5 Boot menu
InsydeH20 Setup Utility
Main Advanced Security Boot Exit
Quiet Boot [Enable]
USB boot [Enable]
ACPI Selection [ACPI 3.0]
►Boot Type Order
►Hard Disk Drive
Item Specific Help
Disables or enables
Booting in Text Mode.
F1 Help ↑↓ Select Item F7/F8 Change Values F9 Setup Default
ESC Exit ←→ Select Menu Enter Select►Menu F10 Save and Exit