Manual Part 3

ManualsBrandsGIGA-BYTE TECHNOLOGY ManualsComputers & Accessories11Mbps USB Wireless LAN Adapter

Figure 3-5. Encryption

3-5. Advanced

By Choosing the Advanced option in any of the two modes, you can change advanced

configuration settings, such as the Preamble Type, Fragmentation Threshold, and

RTS/CTS Threshold (Figure 3-6). Figure 3-5 shows the default configuration for the

advanced settings. The USB adapter has an auto-detection feature therefore when

selecting “Auto” for the preamble type it automatically selects the Preamble Type

depending on the Access Point Preamble type

Note: In order to enable the Fragmentation and the RTS/CTS Threshold parameters move

the slide bar with your mouse and then use the right and left arrow keys of your keyboard

in order to select an exact number.

Summary of content (5 pages)

PAGE 1
Figure 3-5. Encryption 3-5. Advanced By Choosing the Advanced option in any of the two modes, you can change advanced configuration settings, such as the Preamble Type, Fragmentation Threshold, and RTS/CTS Threshold (Figure 3-6). Figure 3-5 shows the default configuration for the advanced settings.
PAGE 2
Figure 3-6. Advanced Settings 3-6. Profiles This option shows you to view your current profile. You can click “New” to create a custom profile. Figure 3-7.
PAGE 3
-7. About By choosing this option, you can view basic information about the utility like the Driver, Firmware and Application Version and this adapter’s MAC address. Figure 3-7.
PAGE 4
Chapter 4. Specification 4-1. System Standards IEEE 802.11b compliant, Wi-Fi compatible Host Interface USB 1.1 Modulation 1Mbps: DBPSK; 2Mbps: DQPSK; 5.5 and 11 Mbps: CCK Transmission Rate 1, 2, 5.5, 11 Mbps Operating Voltage 5V Operating Range Open space: 100 - 300m; Indoor: 30 - 100m 4-2. RF Performance Frequency Band 2.400 ~ 2.
PAGE 5
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.