Installation Instructions Part 2

ManualsBrandsGIGA-BYTE TECHNOLOGY ManualsComputers & Accessories11Mbps USB Wireless LAN Adapter

Step 5: Click “Yes”. The wizard will ask you to click the type of setup.

Step 6: Select “Typical” and then click “Next”. The wizard will ask you to provide the

destination path of where the application will be installed.

Summary of content (5 pages)

PAGE 1
Step 5: Click “Yes”. The wizard will ask you to click the type of setup. Step 6: Select “Typical” and then click “Next”. The wizard will ask you to provide the destination path of where the application will be installed.
PAGE 2
Step 7: You can click “Browse” to set the path or simply only click “Next” to go on. Step 8: Click “Finish”, and then your installation is ok.
PAGE 3
Chapter 3. Using The Utility The Configuration & Monitor Utility is a powerful application that helps you to configure the Fast-VNET card and monitor the statistics of the communication. Unlike the standard method of configuring the adapter via the operating system utilities (e.g. Control Panel), this application permits the dynamic modification of the configuration parameters while the adapter is operating. It also offers some more configuration options.
PAGE 4
Other items in the table are the detailed information about the link status, which are available only when the wireless LAN adapter is connected to an access point or other wireless LAN adapter. SSID: Network name. BSSID: MAC address of the base station. Channel: The current channel used by the wireless LAN adapter. TxRate: The current transmission rate used by the wireless LAN adapter. Reachable Access Points / Stations: This item will show you all of the 802.
PAGE 5
3-3. Configuration A typical screen of the application in Infrastructure mode is shown in Figure 3-4. The configuration parameters are shown at the top of the screen (Operating Mode, Channel, SSID, TxRate, Int. Roaming and Radio of the USB card). In order to change the configuration parameters, click the “Change” button, make your changes and then click “Submit” in order to save your changes. Figure 3-4. 3-4.