GN-WIKG IEEE 802.11b/g Wireless LAN Mini-PCI Card User’s Manual http://www.gigabyte.com.tw Rev. 1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
Contents CHAPTER 1. PRODUCT OVERVIEW 1-1. 1-2. 1-3. 1-4. INTRODUCTION ...........................................................................................................1 FEATURES .................................................................................................................1 PHYSICAL DIMENSIONS/PACKAGING .............................................................................1 SYSTEM REQUIREMENTS ...............................................................................
Chapter 1. Product Overview 1-1. Introduction This 802.11b/g Wireless Local Area Network (WLAN) card is composed of the MAC, Baseband, and radio components, Mini-PCI interface, and two built-in antennas. It operates in 2.4GHz frequency bands, providing fast (up to 54Mbps) and secure (support AES, 802.1x & WEP and WAP) connections to 802.11b and 802.11g networks from a single card. 1-2. Features Conforms to 802.11b/802.11g specification. Transmits data rate up to the maximum speed of 54Mbps.
1-4.
Chapter 2. Installing the WLAN Card This chapter will assist you in completing the hardware and software installation of the GN-WIKG Wireless Mini-PCI Adapter successfully. Please refer to the driver & utility installation section that matches your operating system. 2-1. Installing the Wireless Mini-PCI Adapter Step 1: Turn off your PC and disconnect the power cord. Step 2: Remove the PC cover. Step 3: Locate an available Mini-PCI slot and remove its back plate from the PC chassis.
2-2. Driver & Utility Installation - Windows® 98SE Step 1: When the Add New Hardware Wizard screen appears, click Cancel to exit. Step 2: Insert the GN-WIKG Installation CD into the CD-ROM drive. The GIGABTYE GN-WIKG Wireless Mini-PCI Adapter setup screen appears. Step 3: Drag your mouse over Install Wireless LAN Utility and click on it to start the utility installation program.
Step 4: When the Welcome screen appears, click Next. Step 5: The Check Setup Information screen displays the Operating System of your computer. If it is correct, click Next to continue.
Step 6: An information box screen appears. Click OK to go to the next screen. Step 7: After the software utility installation is complete, click Finish. You are now ready to install 802.1x authentication software. Step 8: Drag your mouse over Browse the CD and click on it.
