User Manual

Electrostatic discharge (ESD)
Attention: ESD damage can occur when there is a difference in charge between
the part, the product, and the service person. No damage will occur if the service
person and the part being installed are at the same charge level.
ESD Damage Prevention
Anytime a service action involves physical contact with logic cards, modules,
back-panel pins, or other ESD sensitive (ESDS) parts, the service person must be
connected to an ESD common ground point on the product through the ESD wrist
strap and cord.
The ESD ground clip can be attached to any frame ground, ground braid, green
wire ground, or the round ground prong on the AC power plug. Coax or connector
outside shells can also be used.
Handling Removed Cards
Logic cards removed from a product should be placed in ESD protective containers.
No other object should be allowed inside the ESD container with the logic card.
Attach tags or reports that must accompany the card to the outside of the container.
Regulatory notice for T60H786 or GN-WIAG02 IBM 802.11 b/g wireless
LAN mini PCI adapter
The IBM Wireless LAN Mini PCI Adapter must be installed and used in strict
accordance with the following instructions. This product complies with the following
radio frequency standards.
USA – Federal Communications Commission (FCC)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Exposure to radio frequency energy
The radiated output power of the Wireless LAN Mini-PCI Card authorized for use in
the IBM 4836/4838 Anyplace Kiosk is far below the FCC radio frequency exposure
limits. Nevertheless, the IBM 4836/4838 Anyplace Kiosk shall be used in such a
manner that the potential for human contact during normal operations is minimized.
CAUTION:
v To comply with FCC RF exposure compliance requirements, a separation
distance of at least 20 cm (8 inches) must be maintained between the
antenna for the integrated Wireless LAN Mini-PCI Card built in to the
display section and all persons.
v The antenna(s) must not be co-located (within 20cm) or operating in
conjunction with any other antenna or transmitter during customer usage.
Updated August, 2006
72 Anyplace Kiosk 4836/4838
|
|