User Manual

Locating and resetting the CMOS jumper
Follow these steps to locate and reset the CMOS jumper:
1. Remove the cover as described in “Removing the back cover” on page 31.
2. Locate the blue CMOS jumper on the main planar assembly. See Figure 18.
The jumper is located near the hard drive and beside the radio card.
3. Remove the jumper from the board and wait several seconds.
4. Reinstall jumper to reset defaults.
Removing the memory card
To remove the optional memory card, reverse the steps listed in “Installing
additional memory” on page 17. To remove the factory-installed memory, follow
these steps:
1. Remove the back cover as described in “Removing the back cover” on page 31.
2. Remove the memory card from its slot.
3. To replace the memory card, reverse these steps.
Figure 18. Location of the CMOS jumper
Updated August, 2006
34 Anyplace Kiosk 4836/4838