User Manual

Removing the cable covers
Follow these steps to remove and replace the cable covers:
1. Open the covers as described in “Opening the cable covers” on page 10.
2. Remove the hinge pin (see Figure 15 on page 30) and lift to remove the covers.
3. To replace, reverse these steps.
Removing the main shield
1. Remove the cover as described in “Removing the back cover” on page 31.
2. See Figure 17 and locate the main shield (B) that is attached to the back
cover (C).
3. Remove the three screws (A) that hold the shield and lift to remove.
4. To replace, reverse this procedure.
A
B
C
Figure 17. Removing the main shield
Updated August, 2006
32 Anyplace Kiosk 4836/4838