User Manual

Wall mount plate mounting options
The wall mount plate and wall cutout dimensions are shown in Figure 14. The I/O
and power cables for the unit can be routed either through the wall behind the unit,
or out the bottom of the rear cover.
Note:
Wall mount plate is not drawn to scale.
Attaching the wall mount plate
CAUTION:
The wall mount plate must be installed by an insured, qualified, professional
installer who is familiar with building construction methods, building
materials, building codes, electrical codes, fire codes, and local laws
governing public access areas.
It is imperative that the wall mount plate is attached securely and permanently to
the wall. The 4836/4838 weighs approximately 6.4 kg (14 lb.), and its weight is
centered approximately 75 mm (3 in.) away from the wall. In addition to this weight,
the wall mount plate must maintain secure and permanent attachment in the event
the unit is knocked, bumped, or otherwise abused. If the wall mount plate is not
securely attached to the wall, the unit might fall and be damaged, and may cause
injury to others.
98 mm
(3.87 in)
186.6 mm
(7.37 in)
200 mm
(7.87 in)
35 mm
(1.37 in)
60 mm
(2.37 in)
18 mm
(0.75 in)
Cable
Exit
Figure 14. Wall mount plate and wall cutout dimensions
Updated August, 2006
Chapter 3. Mounting the IBM Anyplace Kiosk to the wall 23