User Manual

Note: You can bolt the unit to the counter top, using the hole provided in the
mount.
Wall mount
Follow the procedures described in Chapter 3, “Mounting the IBM Anyplace Kiosk to
the wall,” on page 21.
Powering on
Notes:
1. Your new IBM 4836/4838 ships with a control cover. If you want the buttons
covered, install this part after you power on and adjust the image.
2. A small hole (E in Figure 11) under the control cover allows you access to the
reset switch. Use a paperclip or other small tool to activate the switch.
3. A screwdriver is required to pry off the cover.
1. Plug the power adapter into the 4836/4838.
2. Plug the power adapter into an electrical outlet.
3. Power on the IBM 4836/4838 using the power switch (see A in Figure 11). The
4836/4838 power light-emitting diode (LED) will initially appear green.
4. To adjust the brightness, select the plus + (B) or minus - (C) keys.
Installing the control button cover
See Figure 11. To install the control button cover (D), follow these steps:
1. Match the alignment pins on the button cover with the hole between the buttons.
2. Snap into place.
Figure 11. IBM 4836/4838 controls and installing the control cover
Updated August, 2006
Chapter 2. Installing the IBM Anyplace Kiosk 19