User Manual

Mounting instructions
You can choose between a table-top, wall mount, or a third party mount.
Table-top mount
CAUTION:
The illustration above shows the table-top mount for a 12 inch or 15 inch
model. The 17 inch models (137, E37) use a different table-top mount than the
one shown above (see “Assembly 4: Table-top stand and wall mount” on page
58), though the instructions below are the same. Do not attempt to mount a
17 inch model onto the table-top mount for a 12 inch or 15 inch model.
1. Remove the base cover (A) and arm cover (B).
2. Route and connect the cables (C) to the IBM 4836/4838.
3. Close cable cover and tighten thumbscrew (D) on the cover.
4. Close USB cover (optional).
5. Attach the mount to the unit with the four screws.
6. Install the base cover (A) and the arm cover (B).
7. Place the IBM 4836/4838 unit in the desired location and retain the cables (see
“Retaining the cables” on page 11).
Figure 10. Installing table-top mount
Updated August, 2006
18 Anyplace Kiosk 4836/4838