User Manual

Installing additional memory
To install additional memory, refer to Figure 2 on page 8. This figure identifies the
memory access door.
1. Place the 4836/4838 face down on a sturdy surface.
2. See Figure 9. Remove the two captured screws on each side of the memory
door and pull to remove.
3. Insert the memory card into the brackets at an angle with the connector end
down.
4. Rotate the outer edge of the memory card downward until it snaps into place.
Note:
You must remove the back cover if you are replacing both memory modules.
Figure 9. Installing additional memory
Updated August, 2006
Chapter 2. Installing the IBM Anyplace Kiosk 17