User Manual

Installing the MSR (15 and 17 inch models)
Note: Install the MSR after you mount the IBM 4836/4838. See “Mounting
instructions” on page 18.
1. Remove the hard drive door by unfastening the two screws located on the door
and discard.
2. With the IBM 4836/4838 mounted onto the desired stand, locate the mounting
features for the MSR on the right side of the machine.
3. Align the MSR such that the connectors are slightly above their matching slots
on the 4836/4838. The ground strap should lie in the top of the rear cover
opening. Slide the MSR downward into position, being careful not to pinch the
MSR cable. The ground strap should slide under the pressure clip. See 1 in
Figure 7 on page 15.
Updated August, 2006
14 Anyplace Kiosk 4836/4838
|
|
|
|
|
|
|
|
|
|
|
|
|