User Manual

Installing the options

The design of the IBM 4836/4838 allows you to install the hard drive, scanner, and

MSR without removing the external cover. Many upgrade features are

factory-installed. See Figure 2 on page 8 to identify the access doors.

Installing the scanner

1. As shown in Figure 5, place the IBM 4836/4838 face down on a sturdy surface.

2. Lift the cable covers as described in “Opening the cable covers” on page 10.

3. Unfasten the screw (A) holding the scanner bay cover (B). Discard the

cover, but retain the screw for step 6.

4. Connect the scanner cable (C) to the connector (E).

5. Align the tabs (D) on the scanner with the adjacent slots on the cover and

slide into position.

6. Secure in place by inserting the screw (A).

Note:

For best scanning results, hold the object to be scanned 2 to 4 inches away

from the scanner.

Note:

For EIA-232 modes, the scanner may need to be configured. Refer to the

IBM Knowledge Base at the IBM Retail Store Solutions Web site

(http://www.ibm.com/store/support/) for details on configuring the scanner.

Installing the MSR (12 inch models)

Note: Install the MSR after you mount the IBM 4836/4838. See “Mounting

instructions” on page 18.

1. Remove the hard drive door by unfastening the two screws located on the door

and discard.

2. With the IBM 4836/4838 mounted onto the desired stand, locate the mounting

features for the MSR on the right side of the machine.

3. Align the MSR such that the connectors are slightly above their matching slots

on the 4836/4838. The ground strap should lie in the top of the rear cover

Figure 5. Installing the scanner

Updated August, 2006

12 Anyplace Kiosk 4836/4838