User Manual

Retaining the cables
The EIA-232 cable is retained to the system unit with screws. The Ethernet cable is
retained by a snap on the connector. When closed, the cable cover retains the
power cable. See Figure 4.
You can retain the audio cables and USB cables by placing cable ties
1
on the
outside of the covers. The slots in the cable covers retain the ties. Install the cable
ties as follows:
1. Plug each cable into its respective connector.
2. Install the cable ties to the cable just outside the cable cover as shown in A in
Figure 4.
Note:
Ensure that the cable tie is tight and does not move.
3. Open the cable covers (B in Figure 4).
4. Place the cables with the cable ties inside of the cable covers.
5. Close and secure the cable covers with the cable ties inside of the covers (C
in Figure 4).
1. The cable ties are 5 mm (.2 in.) wide.
A
B
C
Figure 4. Retaining the cables using cable ties
Updated August, 2006
Chapter 2. Installing the IBM Anyplace Kiosk 11