User Manual

Removing the LCD

1. Remove the covers as described in “Removing the back cover” on page 31.

2. Remove the eight screws (A) that hold the system board (main planar) and

LCD assembly to the front bezel.

Note:

You do not need to remove the system board from the LCD assembly to

remove the LCD.

3. Disconnect the following cables and connectors:

v Touch cable (see A in Figure 26 on page 42)

v Speakers (see B in Figure 23 on page 39)

v Control card cable (see B in Figure 26 on page 42)

v LCD backlight cables: 2 in the 12 inch and 15 inch units; 4 in the 17 inch unit

(A in Figure 27 on page 43)

4. Remove the LCD assembly (includes system board).

Note:

Take care not to bend the metal antenna (B in Figure 28).

5. Turn the LCD assembly over to locate and remove the four screws that hold the

LCD to the back of the LCD assembly. Remove the LCD.

6. Disconnect the main signal cable from the back of the LCD.

Figure 28. Removing the LCD

Updated August, 2006

44 Anyplace Kiosk 4836/4838