User Manual

Removing the front panel card
1. Remove the back cover as described in “Removing the back cover” on page 31.
2. Remove the system board assembly as described in “Removing the system
board” on page 40.
3. See Figure 26. Disconnect the speaker connections from the card (E).
4. Remove the touch cable (A) as follows:
a. Locate the gray latches on either side of the cable.
b. Pull backward on the latches to release.
c. Slip the cable out of the slots.
5. Remove the control card cable (B) by pulling it out from the card.
6. Unfasten the three screws (C) to remove the card.
7. To replace, locate the alignment pin (D) and hole and lower the front panel
card onto the pin.
8. Replace the three screws.
Figure 26. Removing the front panel card
Updated August, 2006
42 Anyplace Kiosk 4836/4838