User Manual

Removing the processor
Note: See Figure 21 on page 37. Locate the processor (C) after you remove the
heat sink.
To remove the processor, follow these steps:
1. Turn the screw that holds the processor 180° to release it.
2. Lift out the processor, carefully keeping your fingers on each side of the module.
3. To replace, reverse this procedure.
Removing the hard disk drive and bracket
Follow these steps to remove the hard disk drive and bracket:
1. Open the hard drive door (A in Figure 22).
2. Remove the hard disk drive (B) by sliding the drive outward.
3. Remove the four screws (C) that hold the hard disk drive bracket (D) and lift
to remove.
4. To replace, locate the right and left side rails with the correct side of the rails
upward.
5. Replace the 4 screws.
6. Reinstall the hard disk drive and door.
B
A
D
C
Figure 22. Removing the hard disk drive and bracket
Updated August, 2006
38 Anyplace Kiosk 4836/4838