User Manual

Removing the mounting stand cover set
To remove the cover set for the table-top mounting stand, follow these steps:
1. Remove the arm cover (B) by pulling on the finger recess (A in Figure 31)
located on the top of the cover.
Note: Extra pressure may be necessary.
2. Remove the base cover (C) by pulling the cover away from the display.
3. Snap out the cable shield.
4. To remove the plastic base housing, unfasten the four screws.
Figure 31. Removing the stand cover set
Updated August, 2006
Chapter 4. Removing and replacing FRUs 47