User's Manual

(B) USB Driver Installation

Preface

1. Before installing the USB driver, please refer to Section 3-2 for the installation at your PC end.

If “obtain an IP address automatically” is not selected in the installation at your PC, then you

should know the following information:

IP address ranges from “192.168.2.1” to “92.168.2.252”

Subnet Mask “255.255.255.0”

Default Gateway “192.168.2.253”.

2. Follow the “Found New Hardware Wizard” to complete the GN-BR402W USB Driver

Installation.

Steps:

Please connect the power to the GN-BR402W and wait until the GN-BR402W completely boots up

(when the status LED is off). Connect the USB cable to the USB slot on your computer and the

USB slot of the GN-BR402W.

The following screen will appear:

Please press “Next” for next step.