User's Manual
63
6
Getting Connected
COM ports
For example, when you purchase a Bluetooth GPS-supported navigation software; you can register this device as
an effective serial port by following the instructions on the manual of that product and the steps below:
Tap Start > Settings > Connections tab > Bluetooth > COM Ports tab. To register a new serial port:
1. Tap New Incoming Port to enter setup screen.
2. Select a port to be set.
3. Select Finish.
6.4 Wi-Fi
Wi-Fi is a type of wireless local area network that communicates between two devices by high frequency radio
waves. Your MWg Atom V supports Wireless LAN, which is IEEE 802.11b/g compliant. It allows your device to
connect to the Internet with detected wireless network.
To activate Wi-Fi and connect to a local network
1. Tap Start > Settings > Connections tab > Wireless Manager.
2. Tap
Wi-Fi to activate wireless network.
3. Once activated the device will immeduiately look for a local Wi-Fi network, and list those available.
4.Select the appropriate network and you will be promted for a work or internet connection. Usually connect for The
Internet
5.You wil then be promted to enter the network key which is uniuqe for each Wi-Fi network. Enter this code, follow
the prompts and the device will connect to the Wi-Fi network.
To check your Wi-Fi status
Tap Start > Settings > Connections tab > WiFi Utility > Wi-Fi Status tab and you may see the details of your
phone’s wireless LAN connection, including Status, ESSID, BSSID, BSS Mode, Channel, Data Rate, IP Address,
and Signal Strength.
To congure Wi-Fi settings
Tap Start > Settings > Connections tab > WiFi Utility > Setting tab and scroll to set the desired value /mode for
the following setting items: Adhoc Channel, Preamble, Data Rate, Power Save, Power strength, and Auto Power
off. Tab Set button to conrm your setting.
To update IP info
Tap Start > Settings > Connections tab > WiFi Utility > IP Info tab > Renew or Ping button to update IP
information or locate the IP address of the other device.
To search IP address
Tap Start > Settings > Connections tab > Wi-Fi Utility > Site Survey tab > Re-scan button to search the ESSID,
Channel, RSSI, and BSSID of the Wireless LAN.
To change IP address