Owners manual

INSTALLATION INSTRUCTIONS
NOTE: INSTALLATION OF THESE HEADERS REQUIRES AN ADEQUATE WORK SPACE, GENERAL
MECHANIC'S TOOLS, GENERAL MECHANIC "KNOW-HOW" AND A REASONABLE DEGREE OF EXPERIENCE.
1. PLACE VEHICLE IN A LOCATION WHERE THE FLOOR IS SOLID AND FLAT, WITH ADEQUATE
LIGHTING. DO NOT ATTEMPT TO WORK ON A HOT ENGINE. HEAT CAUSES METAL TO EXPAND AND
MAKES REMOVAL OF FASTENERS DIFFICULT.
DISCONNECT THE BATTERY CABLES FROM THE BATTERY. RAISE THE FRONT OF THE VEHICLE TO
OBTAIN ADEQUATE ACCESS TO THE BOTTOM EXHAUST MANIFOLD FLANGES. USE LARGE-BASED JACK
STANDS TO SUPPORT THE VEHICLE. STARTING UNDERNEATH THE VEHICLE REMOVE FACTORY Y-PIPE
ASSEMBLY FROM STOCK MANIFOLDS.
2. NOW STARTING UP TOP ON THE DRIVER SIDE, REMOVE STEERING SHAFT FOR REMOVAL OF
FACTORY MANIFOLDS AND INSTALLATION OF HEADER. DISCONNECT ALL SPARK PLUG WIRES,
REMOVE FACTORY HEAT SHIELDS AND MANIFOLD. MAKE SURE CYLINDER HEAD SURFACE IS CLEAN
OF ANY DEBRIS BEFORE INSTALLATION OF HEADER.