Owners manual

8. Using a scraper, remove all carbon deposits on head surface. At this time apply a high temperature sealer
(O2 sensor safe) to exhaust pipe flare in order to avoid problems due to lack of space later on in the
installation.
9. Installing passenger side header through the top. Using new head gasket + bolts. Use a high temp gasket
sealer (O2 sensor safe) on head gasket. NOTE: Last top bolt use 3/8” or 1/4” extension & socket to install
hardware for easier installation. Torque all fasteners 30 to 35 pounds. Tighten all bolts starting from the
center and working your way out. After passenger side header is installed use 2
nd
supplied heat-wrap and
wire strips to wrap heater hose. Then use supplied zip ties to tie away from header.
10. Reconnect the exhaust system to the header using the hardware provided.
11. Check to make sure there is adequate clearance on battery cables, wire looms, brake lines, etc.
12. Re-connect the battery cables.
13. Recheck and tighten everything!
14. Start the engine and let it warm up. Check for leaks. Shut engine off and let it cool down. Check to make
sure all fasteners are tight.
YOU MUST RE-TORQUE ALL HEADER BOLTS AFTER 100 MILES AND THEN PERIODICALLY
CHECK.
NOTE: IT IS NOT UNUSUAL WHEN INSTALLING HEADERS TO GET A BURNING SMELL. THIS IS
NORMAL AND IT WILL GO AWAY!
PART LIST:
Part # Qty. Description
HE-316 1 DRIVERSIDE HEAD FLANGE
HE-316 1 (NEW)PASSENGERSIDE HEAD FLANGE
9683 1 PASSENGERSIDE GASKET
14030 2 4” X 8” HEAT WRAP
14031 8 6” STAINLESS WIRE STRAPS
3529 16 8” X 1.25” HEADER BOLTS
225 16 5/16” STAR WASHERS
BO-1014 1 BOLT KIT
9689 1 DRIVERSIDE GASKET
ZIP TIES 6 ZIP TIE