Owners manual

WARNING! – Do not rely on bumper jacks or chassis jacks for support
during header installation. The subject vehicle should be raised and
supported with jacking equipment and jack stands or ramps intended
for undercarriage auto maintenance. It is extremely dangerous to
work under an improperly raised and/or supported vehicle.
WARNING! - Make certain there is ample clearance around
components such as brake lines; brake proportioning valves, fuel
lines, hoses and pumps, and electrical components and wires. In
some cases it may be necessary to relocate items that may be
adversely affected by exhaust system heat.
NOTE: These procedures are documented on factory standard-
equipped vehicles with original configuration compliance. Any
modification of the subject vehicle may dictate modification to these
procedures.
IT IS NOT UNUSUAL WHEN INSTALLING HEADERS TO GET A
BURNING SMELL. THIS IS NORMAL AND IT WILL GO AWAY!