Owners manual

WHEN THESE INSTRUCTIONS ARE FOLLOWED PRECISELY, YOU WILL FIND
THE INSTALLATION OF YOUR EXHAUST SYSTEM TO BE RELATIVELY SIMPLE.
WE CANNOT OVER EMPHASIZE THE IMPORTANCE OF ADHERING STRICTLY TO
THIS PROVEN APPROACH, AS IT WILL VIRTUALLY ELIMINATE ANY
DIFFICULTIES, WHICH YOU MIGHT OTHERWISE ENCOUNTER.
DUE TO RESTRICTED ROOM IN THE ENGINE COMPARTMENT, YOUR HEADERS
MAY COME CLOSE TO CERTAIN BODY AND CHASSIS COMPONENTS. THIS IS A
NORMAL CONDITION FOR AN INSTALLATION OF THIS TYPE.
WARNING: MAKE CERTAIN YOU HAVE ENOUGH CLEARANCE AROUND BRAKE,
FUEL, AND ELECTRICAL LINES, ETC. IN SOME CASES, IT MAY BE NECESSARY
TO RELOCATE ITEMS WHICH MIGHT BE ADVERSELY AFFECTED BY EXHAUST
HEAT.
WARNING: INSTALLATION OF ANY TYPE OF "WRAPPING" MATERIAL ONTO THE
HEADERS WILL DESTROY THE HEAT DISSIPATION PROPERTIES OF THE
TUBING, CAUSING PREMATURE DETERIORATION OF THE METAL AND
SUBSEQUENT FAILURE. USE OF ANY "WRAPPING" MATERIAL WILL VOID THE
WARRANTY.
LEGAL STATUS: INSTALLATION OF HEADERS ON VEHICLES WITH CATALYTIC
CONVERTERS AND/ OR OTHER EMISSION CONTROL EQUIPMENT MUST BE
ACCOMPLISHED IN ACCORDANCE WITH ALL GOVERNMENT REGULATIONS
PERTAINING TO SUCH EMISSIONS STANDARDS. THESE HEADERS ARE SMOG
LEGAL.
E.O. STICKER INFORMATION
PLACE THE STICKER IN AN AREA THAT IS PROTECTED FROM HIGH WEAR OR
FREQUENT EXPOSURE TO DIRT, WATER, ETC. MAKE SURE THE AREA IS
CLEAN BEFORE APPLYING. E.O. ARE USUALLY UPDATED ANNUALLY, YOUR
E.O. STICKER DOES NOT NEED TO BE REPLACED TO REFLECT CHANGES THAT
ARE MADE. SMOG INSPECTION STATIONS ARE UPDATED REGULARLY