Owners manual

INSTALL THE DRIVER SIDE HEADER FROM UNDERNEATH THE VEHICLE. SOME TWISTING
AND WIGGLING OF THE HEADER IS NECESSARY.
12. BEFORE INSTALLING THE PASSENGER SIDE HEADER. NOTICE ON PASSENGER SIDE
HEADER, THERE ARE SLOTTED BOLT HOLES ON THE FLANGE. INSTALL NEW BOLTS WITH
THE GASKET LEAVING AT LEAST 3/8 OF INCH GAP THEN INSTALL THE HEADER.
13. APPLY A SMALL AMOUNT OF HI-TEMP SEALER TO THE EXHAUST PIPE FLARE, THEN
INSTALL THE PASSENGER SIDE HEADER THROUGH THE WHEELWELL. ATTACH USING THE
SUPPLIED BOLTS AND GASKETS. APPLY A SMALL AMOUNT OF ANTI-SEIZE TO THE THREADS OF
THE BOLTS BEFORE TIGHTENING.
14. RE-CONNECT THE EXHAUST SYSTEM TO THE NEW HEADERS USING THE HARDWARE
PROVIDED.(RE-CONNECT DRIVE SHAFT WHERE APPLICABLE)
15. RE-INSTALL THE INNER WHEELWELLS (IF REMOVED). CHECK TO ENSURE THAT THERE
ADEQUATE CLEARANCE ON ALL BRAKE LINES, WIRE LOOMS, A/C LINES, ETC. IT IS
RECOMMENDED THAT YOU REMOVE THE PASSENGER SIDE WHEELWELL FLAP.
16. RE-INSTALL THE FRONT WHEELS AND TORQUE TO FACTORY SPECS. (SEE OWNER'S
MANUAL).
17. RECONNECT THE BATTERY.
18. RE-CHECK EVERYTHING!
19. START THE ENGINE, CHECK FOR LEAKS AND TEST DRIVE. THEN LET THE ENGINE COOL AND
THEN RE-TORQUE THE HEADER BOLTS.
20. PERIODICALLY CHECK AND RETIGHTEN THE HEADER BOLTS.
NOTE: IT IS NOT UNUSUAL WHEN INSTALLING HEADERS TO GET A BURNING
SMELL. THIS IS NORMAL AND IT WILL GO AWAY!
PARTS LIST:
(1) DRIVER'S SIDE HEADER ASSEMBLY
(1) PASSENGER'S SIDE HEADER ASSEMBLY
(2) HEADER GASKETS (HEADER TO HEAD FLANGE)
(4) COLLECTOR BOLTS AND NUTS,WASHERS
(16) 8mm X 1.25mm BOLTS WITH STAR WASHERS