Owners manual

INSTALLATION INSTRUCTIONS PART #69124D
WHEN INSTALLING THIS EXHAUST SYSTEM, MAKE SURE TO USE THE PROPER SAFETY
PRECAUTIONS. USE JACK STAND WHEN UNDER TRUCK, SET PARKING BRAKE, BLOCK TIRES,
AND USE SAFETY GLASSES AND GLOVES. DO NOT WORK WITH HOT PIPES!
SUGGESTED TOOLS:
13mm, 15mm SOCKET, 9/16” SOCKET, ½” SOCKET, ½” WRENCH, HACKSAW, JACKSTAND
LAY OUT THE EXHAUST AND COMPARE THE PART NUMBER WITH THE DRAWING
TO REMOVE YOUR STOCK
EXHAUST, UNBOLT AND REMOVE
IT FROM THE CLAMP LOCATED
JUST BEHIND THE FACTORY
RESONATOR. FOR EASIER
REMOVAL OF THE FACTORY
EXHAUST, CUT OFF THE STOCK
TAILPIPE JUST BEHIND THE
MUFFLER AND REMOVE. LEAVE ALL
RUBBER GROMMETS ON THE
HANGERS. USE WD-40 TO AID IN
REMOVAL OF EXHAUST AND
HANGERS.
INSTALL HEADPIPE # A ONTO
FACTORY PIPE. LINE UP THE
NOTCH. USE CLAMP # G TO
SECURE HEADPIPE TO FACTORY
PIPE. DO NOT TIGHTEN. INSERT
WELDED HANGER INTO RUBBER
GROMMET.
INSTALL PASSENGER SIDE
OVER AXLE TAILPIPE # C
INTO MUFFLER 1½ TO 2”.
INSERT WELDED HANGER
INTO RUBBER GROMMET,
USE CLAMP # G TO
SECURE PIPE TO
MUFFLER. THIS PIPE WILL
GO INTO THE PASSENGER
SIDE OUTLET. DO NOT
TIGHTEN
NEXT INSTALL DRIVERS OVER
AXLE PIPE # D INTO MUFFLER
1½ TO 2”.USE CLAMP # F TO
SECURE PIPE TO MUFFLER. DO
NOT TIGHTEN. USE BOLT KIT # H
TO SECURE PIPES TOGETHER.
DRIVERSIDE TAB WILL BE ON
THE BOTTOM.
INSTALL YOUR BLACK
CERAMIC COATED TIPS.
PROCEED TO THE NEXT
SHEET ON HOW TO INSTALL
YOUR DEEGAN 38 BADGES.
AFTER YOU HAVE CHECKED
FOR CLEARANCES GO BACK
AND TIGHTEN ALL NUTS,
BOLTS AND CLAMPS.
GIBSON EXHAUST systems are designed on a factory stock vehicle. Any aftermarket products installed could increase
the sound levels of this Exhaust. Make sure there is a 1” clearance from ALL rubber brake lines, shock boots, fuel lines,
tires, etc to prevent heat related damage .
SLIP MUFFLER #B ONTO THE
HEADPIPE 1 ½” TO 2”. THE
OUTLETS WILL BE LEVEL. USE
CLAMP #G TO SECURE MUFFLER
TO HEADPIPE. DO NOT TIGHTEN.