Owners manual

Installation Instructions #65680
When installing this exhaust system make sure to use proper safety precautions. Use jack stands when working under the
vehicle, set parking brake, block tires and use safety glasses and gloves. Allow exhaust to cool before attempting installation.
Severe injury or burns could occur if safety measures are not taken.
SUGGESTED TOOLS: 1/2", 9/16", 15mm wrenches & sockets, WD-40, hacksaw, jack stands
1. Disconnect the negative battery cable before removal of OEM exhaust. This will allow the computer to reset and recognize
the new exhaust. Lay out the exhaust on the floor so it looks like the drawing and compare parts with manual.
2. To remove your factory
exhaust first cut off your
tailpipe just behind the stock
muffler. Use WD-40 to aid in
removal of your factory
grommets. Do not disguard
you will reuse them.
3. Next remove the rest of
your stock exhaust from the
clamp located in front of the
muffler.
4. Install head pipe #A onto
factory pipe. Use your factory
clamp to secure. Insert
welded hangers into rubber
grommets. Do not tighten.
5. Install muffler #B onto head
pipe #A 1½”-2” with the
louvers facing towards the
converter. Use a jack stand to
support the muffler. Use clamp
#g to secure the muffler to the
head pipe. Do not tighten.
Muffler inlet is looking into the
louvers.
6. Install passenger side
overaxle tailpipe #c into
muffler1.5” to 2” insert welded
hangers into rubber grommets
7. Install drivers side rear
tailpipe hanger onto frame
using factory bolts (see picture)
install rubber grommet onto
hanger
8. Install overaxle tailpipe #d
into muffler 1.5”to2” insert
welded hangers into rubber
grommets use clamp #h to
secure do not tighten
9. Install exit pipes #e onto
your tailpipes adjust to your
personal look use clamps #h to
secure do not tighten.
8. Install stainless steel tip.
Clamp down. When you have
everything in place, firmly
tighten all bolts and clamps
down securely. Use stainless
steel or aluminum cleaner to
polish tips. Inspect all
fasteners after 25-50 miles of
operation and re-tighten as
necessary. You may need to
cut your stock tail pipe back to
get your tip to fit correctly.
GIBSON EXHAUST systems are designed on a factory stock vehicle. Any aftermarket products installed could increase the sound levels of the exhaust.
Make sure there is a 1” clearance from ALL rubber brake lines, shock boots, lines, tires, etc. to prevent heat related damage or fire.