Instructions / Assembly

6”

2”

Mailbox Post

2008 V3

Read instructions before proceeding with assembly. Check parts list to be sure all parts and hardware are included.

TOOLS REQUIRED

1. 40” Post

2. 32” Ground Mount Stake

3. Mounting Bracket

4. *3/4” Phillips Pan Head Screw (8)

5. Small Screw Cap Covers-Black (4)

6 Small Screw Cap Base-Clear (4)

7. #12 x 1-1/2” Phillips Pan Head Screw (4)

8. Large Screw Cap Covers-Black (4)

9. Large Screw Cap Base-Clear (4)

• Electric Drill or Phillips Head Screwdriver

• 1/16” Drill Bit

• Heavy Hammer

• Level (optional)

• Safety Goggles

PARTS INCLUDED

*4 of these items are for mounting your

purchased mailbox

Exploded

View

POSTAL PATRONS ARE REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND

HEIGHT FROM THE STREET. GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41-45 INCHES FROM THE ROAD SURFACE TO INSIDE FLOOR OF THE

MAILBOX AND ARE SET BACK 6-8 INCHES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO THE MAILBOX DOOR.

PAGE 1
TM Mailbox Post Read instructions before proceeding with assembly. Check parts list to be sure all parts and hardware are included. POSTAL PATRONS ARE REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND HEIGHT FROM THE STREET. GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41-45 INCHES FROM THE ROAD SURFACE TO INSIDE FLOOR OF THE MAILBOX AND ARE SET BACK 6-8 INCHES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO THE MAILBOX DOOR. 5 4 6 1. 2. 3. 4.
PAGE 2
MAILBOX POST ASSEMBLY 1 CAUTION: To Avoid Damage, Do Not Hammer Post. Place a scrap piece of wood on top of stake then hammer. STEP 1. DRIVE GROUND MOUNT STAKE INTO GROUND. When driving the ground mount use a piece of scrap wood on top of the stake to prevent splitting. Or dig hole and set in cement. Leave at least 13” above ground.